LorNode V2
LorNode V2 is an ESP32 board with a LoRa radio on it. You program it over USB-C from the Arduino IDE, like any other ESP32 board. The difference is what else is on the board: a 433 MHz LoRa module, a Li-ion charger with battery protection, and a second 3.3 V regulator that your code can switch off to save power.
That makes it a good fit for small things that sit somewhere far from a wall socket, wake up now and then, send a few bytes over LoRa and go back to sleep.
You can buy one on the product page. The design is open source, so you can also build your own from the hardware files.
What's on the board
- ESP32-WROOM-32 module, with Wi-Fi and Bluetooth.
- Ai-Thinker Ra-01 LoRa module (SX1278) for 433 MHz.
- USB-C with a CH340C USB-serial chip. Uploads reset the board for you, no button pressing.
- BOOT and RST buttons.
- Li-ion charger (TP4056) that charges from USB-C or from the CHG IN 5 V pads.
- Battery protection on board (FS312F and FS8205A), so the cell is cut off before it runs too low.
- Two 3.3 V regulators (RT9080). One always powers the ESP32. The other powers the LoRa module, the RGB LED and the USB chip, and can be switched off from code.
- RGB LED (WS2812B).
- Battery and 5 V sensing, so a sketch can read the battery voltage and tell whether 5 V is plugged in.
- Two pin headers with 18 and 15 pins, plus a small header with the LoRa module's spare DIO pins.
- Four M3 mounting holes on a board of about 74 x 44 mm (73.9 x 43.6 mm).
What the library gives you
The LorNode library wraps the board-specific parts so your sketch stays short:
LorNode.loraBegin()sets the LoRa pins and starts the radio.LorNode.led(r, g, b)drives the RGB LED.LorNode.batteryMillivolts()andLorNode.batteryPercent()read the battery.LorNode.externalPower()tells you whether 5 V is plugged in.LorNode.sleepFor(seconds)switches off everything it can and goes to deep sleep.
For the radio itself you use the regular Arduino LoRa library. Nothing new to learn there.
What you can build
The examples are small, working starting points:
- Two boards pinging each other, to see LoRa working and check signal strength.
- A battery beacon that wakes, sends one packet and sleeps.
- A sensor node that sends temperature, humidity and pressure.
- A gateway that listens for LoRa packets and posts them to a server over Wi-Fi.
- A water tank level sensor with its own gateway.
Things to know up front
- Fit the antenna before you transmit. Sending without an antenna can damage the LoRa module.
- 433 MHz rules differ from country to country. Check the local rules for 433 MHz devices before you use the radio.
- Battery readings top out at about 3.95 V on boards shipped so far. The battery itself is fine. See Power and battery.
- We haven't published measured numbers yet for sleep current, battery life or radio range. They are coming, and we would rather give you real figures than guesses.
Where to go next
- New board on your desk? Start with Getting started.
- Wiring something up? See the Pinout.
- Running from a battery? Read Power and battery.
- Sending data? Read LoRa.
- Looking for a function? See the Library reference.
- Something not working? Try Troubleshooting.